You’re then presented with a reboot dialog and confirmation screen. Now is a good time to make sure you have an Ethernet cable going from ETH0 on the router to your computer’s Ethernet port. The subnet mask is set to 255.255.255.0, default gateway of 192.168.1.1 (the IP of the router), and I’ve set the DNS Server to be 8.8.8.8, Google’s public DNS IP. I’ve configured the IP address of my computer to be 192.168.1.2. By default, the EdgeRouter will come configured with an IP address of 192.168.1.1. This will bring up a window titled “Internet Protocol Version 4 (TCP/IPv4) Properties”. A new window will be opened titled “AdapterName Properties” scroll down in the middle box of this window and find the line that says “Internet Protocol Version 4 (TCP/IPv4)” and click on it followed by clicking the properties button on the bottom right. ![]() Now click properties in the bottom left of that dialog. In the example above it’s listed as “Ethernet 3” and clicking on the adapter will bring up a dialog box that says ‘AdapterName Status’. If you’re using a Windows computer to do the configuration, go to the Control Panel, then to Network and Sharing Center, and at the top right you should see your network adapter listed to the right of Connections. Mine doesn’t have one so I’ve used a USB Ethernet adapter.) (A couple of years ago this was easy, but Ethernet ports are becoming increasingly rare on laptops. The first thing you’ll need to do is manually configure your computer’s network interface to an IP address on the same subnet (this means the same IP address range the router is using), and in order to connect to the EdgeRouter you will need a computer with an Ethernet port. As a result, it initially won’t route traffic for you or really do much of what you bought it for. For instance, it comes with DHCP turned off, so it won’t configure the IP address of your computer, and only one port (eth0) is configured with an IP address. Out of the box, the EdgeRouter comes with a very minimal configuration. I figured it would take a couple of hours to document all the steps involved, but a pleasant surprise was a small blurb buried in the quickstart guide (PDF) saying, “You can click the Wizards tab to access the Setup Wizards.” While I’m not sure if these were available the last time I configured this router model, I’m pleased to say a wizard worked perfectly, though there are still more steps required… Getting Connected I picked the EdgeRouter X SFP from the various EdgeRouter models because it supports power over ethernet (POE) on all five ports. So this follow-up entry is the step-by-step guide to setting up this specific router on your boat, and fortunately it turned out to be easier than I remembered.įirst up, I ordered a shiny new EdgeRouter X SFP, easy to do for $69, and dove into configuring. However, I also described configuring the EdgeRouter as not for the faint of the heart, which drew many requests for more detail. around the boat, and is remarkably capable for its cost. ![]() In my feature Marine internet, a connected year on the water, I referenced a Ubiquiti EdgeRouter as the “heart of our boat network.” It manages multiple WiFi and cellular internet connections to multiple computers, tablets, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |